Westar EM-7015 Automatic Transmission Mount

Automatic Transmission Mount for Scion xD

Restore proper drivetrain support with the Westar EM-7015 automatic transmission mount. Built for the 2008-2014 Scion xD, this mount is designed to match OE-style fit, function, and quality for a direct replacement on the automatic transmission application.

Westar EM-7015 is engineered for the Scion xD automatic transmission mount location and uses application-specific materials and a protective finish to help maintain appearance and service life. If you are replacing a worn transmission mount on a 2008 Scion xD, 2009 Scion xD, 2010 Scion xD, 2011 Scion xD, 2012 Scion xD, 2013 Scion xD, or 2014 Scion xD, this part is built to meet the vehicle’s original mounting requirements.

Key Features

• OE-style replacement designed to meet or exceed original quality, fit, and function
• Manufactured with top-quality components under ISO, QS, and TS production standards
• Application-specific design for rubber, hydraulic, vacuum-assisted, or electronic mount systems
• Protective finish helps improve appearance and extend service life
• Direct-fit solution for the Scion xD automatic transmission mount application

Detailed Description

The Westar EM-7015 automatic transmission mount is a direct replacement part for the 2008-2014 Scion xD. It is built to support the transmission assembly and maintain proper alignment between the drivetrain and chassis. This helps preserve factory-style mounting geometry and consistent driveline support in daily driving conditions. This part cross-references DEA Products A62068 for the same application.

Common Problems This Part Can Address

• Excessive drivetrain movement under acceleration or shifting
• Vibration transferred into the cabin from a worn mount
• Clunking or shifting noise caused by deteriorated mount material
• Misalignment of the transmission support point
• Visible cracking, separation, or collapse of the original mount

Installation Notes and Tips

Confirm automatic transmission application and verify the mount position against the removed part before installation. Inspect adjacent mounts and brackets for wear or damage, since a failed support component can place added stress on the replacement part. For best results, compare the old mount’s shape and mounting points to the Westar EM-7015 before final tightening.

Quality Assurance

Westar designs this mount to follow OE-level expectations for fit and function and manufactures it with controlled production standards. The brand also uses a finish intended to help protect the part and support longer service life.