Wilson 91-01-3706 Starter

Remanufactured Starter for OE-Style Starting Performance

The Wilson 91-01-3706 remanufactured starter is built for 12-volt starting systems and uses a DD design with a 10MT series configuration and 9 teeth. It is remanufactured to meet or exceed OE standards through in-process inspections and testing, with gauged, sorted, renewed, and replaced components where needed.

For buyers searching for a remanufactured starter for Delco Remy applications, this unit provides a direct-service replacement option for electrical, charging, and starting repairs. The Wilson 91-01-3706 is also a practical match for vehicle service work involving starter replacement on Chevrolet and GMC applications that use the same OE-style setup.

Key Features

• Remanufactured starter for 12-volt starting systems
• DD design with 10MT series construction
• 9-tooth drive configuration
• Built to Wilson standards with in-process inspection and testing
• OE unit reference: Delco Remy
• Cross-reference part number: Dayco 87828

Product Details

Wilson remanufactured starters are processed with component gauging, sorting, testing, and renewal during production, and critical wear parts are replaced with new components. That approach supports consistent electrical starting performance for service jobs where the original starter has failed, cranks slowly, or no longer engages properly. This part number, 91-01-3706, is a remanufactured starter intended for OE-style replacement in Delco Remy-based applications.

Fits Chevrolet and GMC starter applications that use the same 12-volt, DD, 10MT, 9-tooth configuration. The 91-01-3706 is a useful search match for technicians and parts buyers looking for a remanufactured starter for Chevrolet and GMC vehicles with Delco Remy OE equipment.

Common Issues This Starter Can Address

• Engine cranking slowly during startup
• No-crank condition caused by starter failure
• Intermittent starter engagement
• Starter drive wear or poor tooth engagement
• Electrical starting problems tied to a worn OE starter

Installation Notes and Tips

Verify the OE starter design, tooth count, voltage, and mounting configuration before installation. Confirm the vehicle uses a Delco Remy-style starter application and compare the original unit to part number 91-01-3706 for proper match-up. Clean battery connections, inspect cables, and check charging-system condition during replacement to help avoid repeat starting complaints.

Quality Assurance

Wilson remanufactured starters are produced under strict inspection and test procedures, with renewed components and replaced wear items where required to meet Wilson standards. This remanufactured starter is built to meet or exceed OE expectations for service replacement.