Wilson 91-29-5515 Starter

Remanufactured 12V Starter for OE Applications

Wilson remanufactured starter Part Number 91-29-5515 is built for 12-volt starting systems and uses an OSGR design with 3.0 kW output and 11 teeth. It is remanufactured to meet or exceed OE standards through in-process inspections and testing at each stage of production.

Built around the original DENSO OE unit, this starter is a direct-fit solution for vehicles that require dependable cranking performance and consistent engagement. The Wilson remanufactured starter 91-29-5515 is a practical choice for OE-style replacement service on select make/model applications.

Key Features

• Remanufactured starter for 12V electrical starting systems
• OSGR design for controlled gear engagement
• 3.0 kW output rating
• 11-tooth drive configuration
• Built from an original DENSO OE unit
• Components are gauged, sorted, tested, and renewed during remanufacturing
• Vital parts are replaced with new components during the process

Product Details

Wilson’s remanufactured starter line focuses on restoring core components to strict production standards. Each unit is inspected and tested throughout remanufacturing, with worn parts renewed and critical pieces replaced as needed. That process helps deliver a starter that matches the electrical and mechanical requirements of the original application while maintaining OE-style fit and function.

This part cross-references DENSO 228000-8180 and 228000-8181 for the same application. If you are searching for a starter for select Honda Civic or similar OE-equivalent applications, Part Number 91-29-5515 is the reference to verify against your original unit.

Common Starting Problems It Can Address

• Slow or weak engine cranking
• No-crank condition when the battery and cables test properly
• Intermittent starter engagement
• Grinding or poor gear mesh during startup
• Starter failure caused by worn internal electrical or drive components

Installation Notes and Tips

Verify the original starter’s OE number, tooth count, voltage, and mounting style before installation. Confirm that the vehicle uses the DENSO-style application referenced by Part Number 91-29-5515, and compare the removed unit to the replacement starter before bolting it in place.

Inspect battery condition, cable connections, and charging-system output before replacing the starter. Clean all mounting surfaces and electrical terminals to support proper current flow and starter engagement.

Quality Assurance

Wilson remanufactured starters are processed with in-process inspections and testing to help ensure each unit meets Wilson standards and OE-level expectations. The remanufacturing process includes gauging, sorting, testing, and renewal of components, with new parts used where required to restore function.