Wix WL10053 Hydraulic Filter

WIX WL10053 Hydraulic Filter Overview

The WIX WL10053 is a spin-on hydraulic filter built for heavy-duty hydraulic systems that need consistent flow control and dependable contaminant capture. It uses 10-micron cellulose media and a 24-28 GPM flow range to support demanding equipment service intervals.

For buyers searching hydraulic filter replacement options for Bobcat, Ford, or other equipment using this application, the WL10053 offers a practical OE-style service part with a 1 3/8-12 thread and outside-in flow direction.

Key Features

• Spin-on hydraulic filter design for service-friendly replacement
• 10-micron cellulose media for fine particle filtration
• Outside-in flow direction for hydraulic circuit operation
• 24-28 GPM flow rate for heavy-duty use
• Bypass relief valve set at 50 psi
• 1000 psi burst pressure and 100 psi collapse pressure rating
• 3.750 in. outer diameter and 6.104 in. height
• WIX HD hydraulic filter construction with corrosion-resistant components

Detailed Description

The WIX WL10053 hydraulic filter is engineered for high-demand hydraulic systems where clean fluid is critical to pump, valve, and actuator performance. WIX uses application-specific media and durable internal components, including a strong center tube and sealing elements built to resist leaks under operating stress. The WL10053 is a direct-fit hydraulic service filter for equipment that specifies this size, thread, and flow configuration, including Bobcat and Ford applications where this part number is referenced.

This part cross-references Donaldson P580465 for the same application. The WIX WL10053 is also listed alongside Fleetguard HF29083 in interchange data.

What It Helps Address

• Hydraulic fluid contamination that can accelerate wear
• Restricted flow caused by a loaded or aging filter
• Pressure spikes in heavy-duty hydraulic circuits
• Leak concerns from worn sealing surfaces
• Service interval replacement for OEM hydraulic maintenance schedules

Installation Notes and Tips

Verify thread size, height, outer diameter, and flow direction before installation. Confirm the system calls for a spin-on hydraulic filter with a 1 3/8-12 thread and outside-in flow. Replace the filter during scheduled hydraulic service and check for proper sealing after startup.

Quality Assurance

WIX recommends this hydraulic filter for OEM hydraulic filter change intervals. Its construction uses corrosion-resistant materials, reinforced media options, and sealing components intended to maintain leak-resistant performance in heavy-duty operation.