GKN Loebro 300501 CV Joint Boot Kit - Rear
OE Quality 60-Day Returns
GKN Loebro

GKN Loebro 300501 CV Joint Boot Kit - Rear

Brand GKN Loebro 300501
Position Rear
Joint End Inside Diameter 3.897
Shaft End Inside Diameter 0.944
Rib Quantity 1
Boot Material Rubber
Vented Boot No
Boot Color Black
Split Or Solid Type Solid
Fits Porsche · 1 vehicle

OE quality boot kit. From a global drive systems leader for dependable repairs.

Rubber construction. Helps protect the joint from tears, slips, and porosity.

Solid boot design. Built for exact fit and reliable protection.

Cross-references 95133190300 and 95133290300 for the same application. See all 2.

$32.46Free shipping
In stock · usually ships same day before 1pm CST
Step 1 — Confirm fitment
Free return shipping if it doesn't fit when you check fitment here first.

Select your vehicle to confirm fitment
Verify this part fits before purchasing — free returns if it doesn't
Step 2 — Quantity
Order total $32.46
Free shipping to the continental U.S.
Free returns within 60 days if it doesn't fit when fitment is verified.
Not what you need? See all CV Joint Boot Kit options

OE-Quality CV Boot Kit for Porsche 968

GKN Loebro 300501 is a solid rubber CV joint boot kit built for rear driveline service on the 1995 Porsche 968. It is made to match the joint’s dimensions and material requirements, helping restore a proper seal around the CV joint.

  • Fits 1995 Porsche 968, rear
  • Premium OE-quality replacement from GKN Loebro
  • Solid boot design with black rubber construction
  • Joint end inside diameter: 3.897 in.
  • Shaft end inside diameter: 0.944 in.
  • Single-rib design for the specified application
  • Non-vented boot construction

Built to Match the Original Application

Part number 300501 is engineered as a direct-fit CV joint boot kit for the rear axle application on the 1995 Porsche 968. GKN Loebro emphasizes exact fit and correct material selection because torn, slipped, or porous boots are common causes of CV joint damage. This replacement boot uses rubber construction and a solid profile to help maintain grease retention and keep contaminants out of the joint. If your original driveshaft uses a rubber boot, this GKN Loebro 300501 kit is the correct style to look for when servicing the Porsche 968 rear driveline.

Common Problems This Part Addresses

  • Torn CV boot leaking grease
  • Boot that has slipped off the joint or shaft
  • Cracked or porous boot material
  • Contamination entering the CV joint
  • Noise or wear caused by loss of lubrication

Installation Notes and Tips

Confirm the joint-end and shaft-end dimensions before installation so the boot seats correctly on the Porsche 968 rear application. Clean the CV joint thoroughly before assembly and inspect the joint for wear, scoring, or contamination before installing the new boot. This part cross-references Porsche 95133190300 and 95133290300 for the same application.

Quality Assurance

GKN Loebro supplies OE-quality driveline components and replacement boot kits designed around the original joint specifications. Part number 300501 is intended for professional repair work where exact fit and correct boot material are critical to long-term CV joint protection.

Related reading

This part fits 1 vehicle
Always verify fitment with your vehicle's VIN if unsure. Submodel & trim restrictions may apply.
YearMakeModelDrive TypeLitersCylindersPositionNotes
1995Porsche968RWD3.0LL4Rear—
Directly replaces or cross-references 2 part numbers
Cross-reference numbers are provided for identification purposes only. Always confirm fitment before ordering.
9513319030095133290300