GKN Loebro 306598 CV Joint Boot Kit - Front Right Inner

OE-Quality CV Boot Kit for BMW X5 and X6

GKN Loebro 306598 is a premium OE-quality CV joint boot kit built for precise replacement on the front right inner position. It is designed for 2014-2018 BMW X5 and 2015-2019 BMW X6 applications, where exact fit and correct boot material are critical to protecting the joint from contamination and grease loss.

This GKN Loebro 306598 boot kit uses TPE construction and includes grease for a professional driveline repair. It is a solid black boot with a 124 mm length, standard replacement grade, and the correct dimensions for the specified joint and shaft ends.

• Fits 2014-2018 BMW X5, front right inner
• Fits 2015-2019 BMW X6, front right inner
• OE-quality replacement from GKN Loebro
• TPE boot material for the original application type
• Solid black boot with 124 mm length
• Includes grease for CV joint service
• Standard replacement design for exact-fit repair

Detailed Product Information

GKN Loebro 306598 is engineered as a direct-fit CV joint boot kit for BMW X5 and BMW X6 driveline service. The boot is the barrier that keeps grease in and road debris out, and the correct fit matters because torn, slipped, or porous boots are common causes of CV joint failure. This kit is built around the specified joint geometry, with a 3.189-inch joint end inside diameter and a 0.984-inch shaft end inside diameter.

For vehicles originally equipped with a TPE boot, matching the replacement material is important. This part number 306598 follows that requirement and is intended for the front right inner position on the listed BMW models. This part cross-references Four Seasons 36419 for the same application.

Common Problems This Boot Kit Addresses

• Grease leakage from a damaged CV boot
• Road dirt and moisture entering the CV joint
• Boot cracking, tearing, or splitting from age and wear
• Noise or vibration caused by a contaminated joint
• Need for a correct-fit replacement on BMW X5 and BMW X6 front right inner driveline service

Installation Notes and Tips

Confirm the original boot style and material before installation, especially on vehicles that use TPE. Match the joint end and shaft end dimensions to the existing driveline component, and verify the front right inner position before service. Clean the joint thoroughly before installing the new boot and follow the vehicle service procedure for clamp and fastener torque.

Quality Assurance

GKN Loebro is part of a global driveline systems manufacturer known for OE-level drive component engineering. This boot kit is supplied as a standard replacement part for professional CV joint repair and is built to the application-specific fit required for BMW X5 and BMW X6 driveline service.