GKN Loebro 306652 CV Joint Boot Kit - Front Inner

OE-Style CV Boot Kit for Porsche 911

GKN Loebro 306652 is a premium OE-quality CV joint boot kit for the front inner position on select Porsche 911 models. Built with the correct fit and material selection in mind, it helps protect the joint from contamination and grease loss when the original boot is damaged.

For Porsche 911 front inner service, exact boot fit matters. This GKN Loebro 306652 boot kit uses rubber construction and a solid design to match the application requirements of the joint.

Key Features

• Fits 1999-2013 Porsche 911, front inner
• GKN Loebro part number 306652
• Rubber boot material with black finish
• Solid boot design, non-vented
• Joint end inside diameter: 1.732 in.
• Shaft end inside diameter: 0.669 in.
• Single-rib boot profile for application-specific fit

Detailed Description

This CV joint boot kit is designed for the front inner CV joint on Porsche 911 models from 1999 through 2013. GKN Loebro 306652 is built to OE-quality standards and is intended to restore the protective seal around the joint when the original boot has torn, slipped, or become porous. The correct boot material and dimensions are important for maintaining a proper seal and reducing the risk of joint contamination.

This part cross-references Porsche OE numbers 996.349.293.00 and 99634929300 for the same application. If you are searching for a Porsche 911 front inner CV boot kit, 306652 is the direct fitment reference to verify against your vehicle and joint configuration.

Common Repair Uses

• Replacing a torn front inner CV boot on a Porsche 911
• Addressing grease leakage around the driveshaft joint
• Repairing a boot that has slipped out of position
• Restoring protection after boot cracking or porosity
• Servicing the CV joint before contamination causes further wear

Installation Notes and Tips

Confirm the joint end and shaft end dimensions before installation, and match the boot material to the original application. For Porsche 911 front inner service, inspect the CV joint for wear, contamination, and grease condition before installing the replacement boot. Proper seating and clamp tension are important for long-term sealing performance.

Quality Assurance

GKN Loebro supplies OE-quality driveline components backed by its experience as a global drive systems manufacturer. This boot kit is engineered for application-specific fit and material matching to support reliable CV joint protection on the Porsche 911.